3 ton of coal produces how much steam

Details


  • Production capacity: 7-70 MW
  • Work pressure: 1.0-1.6 Mpa
  • Applicable fuel: Nature gas, coke oven gas, blast furnace gas, carbon black off-gas, biogas, methanol, etc.
  • Applicable industry: heat suppling, hospital, colleges and universities.


Product introduction

  SZS Series Boiler is double drums, longitudinal arranged, "D" type chamber structure. Furnace is on right side and convection tube bundle is on the left. The body is fixed on the basement by middle and both end flexible supports and make the boiler to expand horizontally to sideways. Around furnace is membrane water cooling tube wall. Furnace and tube bundle is totally separated by the membrane water tube cooling wall at the left side of the furnace. The back part of bundle is sparse shift structure, front part is aligned structure. Smoke from furnace outlet enters re-burning chamber, bundle area, and then from left front part enters spiral fin coil economizer and condenser, finally discharged to atmosphere through chimney.





Safety

  Boiler body high temperature area adopt forced circulation to make sure each part heating area can be cooled down and avoid vaporization;

  Boiler has explosion door and flame detector for safe and reliable operation.

  comb plates are used as the sealing between both sides of boiler and tube bundle all use to avoid leakage of condensate and gas which is caused by refractory concrete sealing.

  air tightness test is done before leaving the factory to ensure no leakage of gas.

environmental protection

  Bigger combustion chamber and Low emission combustion engine to reduce the NOX to 30mg/Nm3

  Smoke duct and smoke outlet has internal insulation to reduce operating noise.

  Combustion chamber use full membrane water cooling wall structure, pressurized firing without smoke mixture.

energy conservation

  Good quality alumina silicate fiber and fire clay insulation is used, boiler body temperature is controlled below 45℃, to reduce heat lost.

  Combustion chamber use narrow distance tube membrane water cooling wall which has good air tightness, and reduce heat lost and increase boiler thermal efficiency.

  Inside of Inspection holes use high-alumina refractory and man hole cover sealing devices, it solved the high temperature of this part by using refractory brick

Convenience

  Thera are manholes on front and back side of both bundle and inspection doors on back side of boiler, which are easy to open for inspection and cleaning inner part.

longer lifespan

  Membrane structure of Front and back wall is used for boiler body, which highly increased their lifespan to over 20 years.

  The key part such as material cutting, rolling, drilling are proceeded by advanced CNC machining process to reduce the assemble stress and extend boiler working lifetime.

  flutter prevention fastener is used for high temperature part convection tube, which avoid bundle tube cracking problem.

  Longitudinal and girth joint adopt advanced automatic submerged-arc welding for good welding quality. All longitudinal and girth joint will have 100% radiographic inspection.

 
Items
Model
SZS7-1.0/115/70-Q SZS10.5-1.0/115/70-Q SZS14-1.25/115/70-Q SZS17.5-1.25/115/70-Q SZS21-1.25/130/70-Q SZS29-1.25/130/70-Q SZS46-1.6/130/70-Q SZS58-1.6/130/70-Q SZS70-1.6/130/70-Q SZS116-1.6/130/70-Q
Rated thermal power(MW) 7.0 10.5 14.0 17.5 21.0 29 46 58 70 116
Rated working pressure(MPa) 1.0 1.0 1.25 1.25 1.25 1.25 1.6 1.6 1.6 1.6
Rated output water temperature(℃) 115 115 115 115 130 130 130 130 130 130
Rated Feeding water temperature(℃) 70 70 70 70 70 70 70 70 70 70
Heating area(㎡) Main body(㎡) 168.0 220.0 245.30 284.40 394.75 428.1 1065.9 1225.7 1408.4 6164.8
Condenser (㎡) 164.0 306.0 527.0 645.1 738.3 990.8 985.3 1292.5 1642.1 1830
Available fuel Natural gas, biogas, coke oven gas, light oil, methanol, biodiesel etc
Gas consumption(Nm³/h) 720 1080 1440 1800 2160 2982 4680 5760 7200 11880
Thermal efficiency(%) >98 >98 >98 >98 >98 >98 >98 >98 >98 >98
MAX.transportation weight(t) 42.0 48.0 52.5 57.5 65.0 72.5 散件12.6 散件13.8 散件16 散件20
MAX. transportation dimension LxWxH(m) 7.87x3.40x3.34 8.85x3.85x3.93 8.51x3.85x3.75 9.31x3.77x3.75 10.10x4.13x4.15 10.90x4.13x4.15 11.00xΦ1.45 11.10xΦ1.46 12.00xΦ1.66 12.50xΦ1.66

CONTACT FORM



How to Calculate the Coal Quantity Used in a Power Plant Heat rate is the heat input required to produce one unit of electricity. I m boiler operator I dont know 1 ton steem generation how much coal required tel me 3. Steam plant heat rate divided by boiler eficiency gives you the Plant heat rate. How much coal, natural gas, or petroleum is used to generate a Feb 29, 2016 1,927 kWh per ton, or 0.96 kWh per pound, of coal; 99 kWh per Mcf (1,000 cubic feet) of natural gas Power plant heat rates (for steam electric generators in 2014) How much shale gas is produced in the United States? Energy in a Ton of Coal Hypertextbook May 20, 2006 Coal produces heat energies of 28 million to 38 million joules per July 1998: 3. Ever wondered how much energy you could get out of a ton of coal, Lignite is primarily used as fuel for steam to generate electric power. How Coal Works | Union of Concerned Scientists Young coal is called lignite, and is soft and brown, not much different than . In 1950, underground mines produced 382 million metric tons, 75 percent of the coal produced. A 500 megawatt coal plant uses 2.2 billion gallons of water a year, for cooling and for steam . At a growth rate of 3 percent, it happens at 73 years.

Water consumption from coal plants SourceWatch Sep 24, 2012 To produce and burn the 1 billion tons of coal America uses each year, Additionally, the debris from mountaintop removal is often pushed 2 Mountaintop removal and water; 3 Clean Coal and Increased Water Usage electricity through converting the water into high-pressure steam to drive turbines. Benchmark the Fuel Cost of Steam Department of Energy produce 1 lb of saturated steam at different operating pressures and varying feed- Coal, ton. 27,000,000. 90.3. Note: Combustion efficiency is based on boilers preheaters and 3% oxygen in flue gas. many other industrial efficiency. Why Does One Ton Of Coal Make 2.86 Tons Of Carbon Dioxide Dec 14, 2008 I said that for each ton of coal burned, it produces 2.86 Tons of CO2. (brown coal) produces even more CO2, in fact one third as much .. 3.We look Best with a minimum Screen resolution of 1024768 and Firefox Browser. Steam Cost analysis CDM ASE. 4, Description, UOM, Steam cost with DOC, Steam cost with SD with Lignite, Steam cost with Imported Coal, Steam cost with Natural Gas 13, Fuel consumption, Tonne/hr or SCM/hr, 2.430, 2.990, 0.995, 1.991, 2.118, 1086.361. Nuclear Fission Energy In the pressurized water reactor (PWR), the thermal energy produces steam for This is the energy equivalent of 3 tons of coal or about 600 gallons of fuel oil per about twice as much electricity is generated from sup239/supPu as is generated from

How to Calculate the Coal Quantity Used in a Power Plant Heat rate is the heat input required to produce one unit of electricity. I m boiler operator I dont know 1 ton steem generation how much coal required tel me 3. Steam plant heat rate divided by boiler eficiency gives you the Plant heat rate. How much coal, natural gas, or petroleum is used to generate a Feb 29, 2016 1,927 kWh per ton, or 0.96 kWh per pound, of coal; 99 kWh per Mcf (1,000 cubic feet) of natural gas Power plant heat rates (for steam electric generators in 2014) How much shale gas is produced in the United States? Energy in a Ton of Coal Hypertextbook May 20, 2006 Coal produces heat energies of 28 million to 38 million joules per July 1998: 3. Ever wondered how much energy you could get out of a ton of coal, Lignite is primarily used as fuel for steam to generate electric power. How Coal Works | Union of Concerned Scientists Young coal is called lignite, and is soft and brown, not much different than . In 1950, underground mines produced 382 million metric tons, 75 percent of the coal produced. A 500 megawatt coal plant uses 2.2 billion gallons of water a year, for cooling and for steam . At a growth rate of 3 percent, it happens at 73 years. Water consumption from coal plants SourceWatch Sep 24, 2012 To produce and burn the 1 billion tons of coal America uses each year, Additionally, the debris from mountaintop removal is often pushed 2 Mountaintop removal and water; 3 Clean Coal and Increased Water Usage electricity through converting the water into high-pressure steam to drive turbines.

Benchmark the Fuel Cost of Steam Department of Energy produce 1 lb of saturated steam at different operating pressures and varying feed- Coal, ton. 27,000,000. 90.3. Note: Combustion efficiency is based on boilers preheaters and 3% oxygen in flue gas. many other industrial efficiency. Why Does One Ton Of Coal Make 2.86 Tons Of Carbon Dioxide Dec 14, 2008 I said that for each ton of coal burned, it produces 2.86 Tons of CO2. (brown coal) produces even more CO2, in fact one third as much .. 3.We look Best with a minimum Screen resolution of 1024768 and Firefox Browser. Steam Cost analysis CDM ASE. 4, Description, UOM, Steam cost with DOC, Steam cost with SD with Lignite, Steam cost with Imported Coal, Steam cost with Natural Gas 13, Fuel consumption, Tonne/hr or SCM/hr, 2.430, 2.990, 0.995, 1.991, 2.118, 1086.361. Nuclear Fission Energy In the pressurized water reactor (PWR), the thermal energy produces steam for This is the energy equivalent of 3 tons of coal or about 600 gallons of fuel oil per about twice as much electricity is generated from sup239/supPu as is generated from